Unimog · 2000–heute
Unimog Unimog Steuergerät Reparatur
Steuergerät im Unimog Unimog (2000–heute) defekt? Wir reparieren ABS Steuergerät, Motorsteuergerät und Sonstige für dieses Modell. Revonik prüft und repariert das eingebaute Originalgerät auf Bauteilebene — deutlich günstiger als ein Neuteil, in 2–4 Werktagen und mit 24 Monaten Gewährleistung.
- 24 monthsWarranty
- Diagnostic check €69credited against the repair cost
- 2–4 working daysStandard repair
- Original unitnot an exchange part
Passende Steuergeräte für den Unimog
Alle Steuergeräte, die im Unimog Unimog verbaut sind und von Revonik repariert werden.
ABS control unitab 579 €Wabco EBS3/EBS4 control unit
24-month warrantyDetails →Engine control unitab 549 €MCM2 control unit24-month warrantyDetails →Engine control unitab 459 €Temic PLD control unit24-month warrantyDetails →Otherab 690 €CPC4 control unit24-month warrantyDetails →Otherab 690 €PSM control unit24-month warrantyDetails →
24-month warrantyDetails →Engine control unitab 549 €MCM2 control unit
24-month warrantyDetails →Engine control unitab 459 €Temic PLD control unit
24-month warrantyDetails →Otherab 690 €CPC4 control unit
24-month warrantyDetails →Otherab 690 €PSM control unit
24-month warrantyDetails →Common error codes
Diese Fehlercodes treten bei den Steuergeräten des Unimog häufig auf.
| Code | Description | Control unit |
|---|---|---|
| 0F0E04 | An internal control unit fault has been detected * | MCM2 control unit |
| 1C0303 – SPN: 796 – FMI: 3 | Front right ABS solenoid valve – short circuit to positive | Wabco EBS3/EBS4 control unit |
| 7C0202 | The assignment of the crankshaft and camshaft signals is incorrect * | MCM2 control unit |
| 8E0203 | The component "Y611 y2 solenoid valve, nozzle needle, cylinder 4" is reporting a time-out error * | MCM2 control unit |
| 8F0203 | The component "Y612 y2 solenoid valve, nozzle needle, cylinder 5" is reporting a time-out error * | MCM2 control unit |
| 35F0FF | Fehler im Fehlerspeicher | Wabco EBS3/EBS4 control unit |
| 00162 | Communication fault with the FR speed control unit | PSM control unit |
| 02723 | No signal to auxiliary drive 1 (pin X4 18/16) despite feedback from auxiliary drive 1 (pin X3 15/7) | PSM control unit |
| 04024 | internal error | Temic PLD control unit |
| 4805 | A plug-in pump on Bank 1 has a short circuit to positive | Temic PLD control unit |
| 4905 | A plug-in pump on Bank 2 has a short circuit to positive | Temic PLD control unit |
| 07543 | Battery voltage too low | Temic PLD control unit |
Contact formIs the control unit faulty?
Is the control unit faulty?
We’ll look into it.
Please send us your enquiry — we’ll usually get back to you within 24 hours with an estimate.
